- Designed to fit '79-up GM Metric spindles
- Allows your front hubs to be tight with minimal drag and side pre-load
- Easy adjust threaded sleeve and set screw ensure you'll never worry about an over-tightened front hub again
- Sold each
I would definitely buy it again
Summary: I put this product on my front rotors of my sportmod race car.
Yes, I recommend this product.
The least expensive part to improve proformance on the marke
Summary: Using them on all four stock cars.
Yes, I recommend this product.
I will defiantly buy this again
Summary: I did not use the tool to adjust, just saves time on set up. Do not over tighten the set screw it will damage the threads and make it very hard to readjust.
Yes, I recommend this product.
very nice product
Summary: Big difference in the drag on the bearings. I set them up without using the setup tool, but I can see where the tool would make it a lot faster. I would recommend marking alinement once set.
Yes, I recommend this product.
I plan on buying enough of these for 3 hobby stocks!
Summary: Looks like a good product for my cars to free up wheel resistance for more on track speed !
Yes, I recommend this product.
