General Safety Information

FOLLOW THIS INSTRUCTION CAREFULLY! Don’t install it before reading this manual.
All modifications to wiring or electrics, and any adjustment or maintenance to AC 220V MUST be done by a qualified electrician.
There has a waterproof box to protect the board.
The board mustn't be exposed to sources of heat or electromagnetic fields. Install the board in anairy place and far from inflammable material.
The factory declines any responsibility in case of a not correct installation or improper use.

Assembly & Mounting

1.Your control board should arrive with the waterproof case installed. Open the case, and use a screwdriver to remove the board from the case.
2.Drill 4 holes in the bottom of the case.
3.Press the case against the wall on which you desire to install your control board. Make 4 dots on the wall through the holes using a pencil or an equivalent (not included).
4.Drill 4 holes where the dots were marked using the selected drill bit, being sure you go at least 3.9cm into the wall.
5.Hammer the anchors into the holes using your hammer(notice.) Mount the case and use the provided mounting screws ensuring that its waterproof cables hole face down.
6.Install the control board and secure it with screws.
7.Connnect the Motor and photocell sensor as Fig 2 and Fig 3 showed.
8.Check and confirm the security and power of the device.