Since 1990 Bill's Hot Rod Co. has had one goal in mind; to design alternator, air conditioner and power steering brackets that fit and are easy to use, as well as affordable and stylish. The 1100 Series alternator brackets fit GM 10-SI or 12-Si alternators. Brackets position the units over the exhaust manifold, and just to the outside of the valve covers, for a low profile look. Brackets come completely assembled with all stainless steel bolts and washers, illustrated instruction sheet, and belt size recommendations with adjusting tips.
- Side Mount Alternator Bracket
- Fits late Small Block Chevy
- Comes completely assembled
- For long water pump
- Fits GM 10-Si or 12-Si alternator
- 1/4"" mild steel plate is used for strength and durability
- No drilling or tapping necessary
- Choose between black, chrome, and raw finishes
Notes:
To protect and preserve the finish on these powdercoated or chrome plated brackets, be sure to apply a good qualitysuch as carnauba, as needed.
Bracket mounts using only the existing factory drilled holes found on the front face of the heads.
Excellent Product
Summary: This bracket worked great on my SBC 350 in my 2978 Firebird.
Yes, I recommend this product.
Yes I would buy this again
Summary: Bolted up fine
Great product, well made and perfect fit
Summary: All the parts were there and fully assembled so there was no confusion about how it was to go. Directions were very clear to understand. Easy to install and use. They even suggest fan belt numbers to use!!!
Yes, I recommend this product.
Yes
Summary: The correct parts fit great
Yes, I recommend this product.
When in need, chek Speedway
Summary: Used to complete a Vintage Air install in a 1955 Nomad
Yes, I recommend this product.
