This is for the wall mount only, no planes or figures included.

This listing is for an easy to install multi directional wall mount system for displaying a variety of G.I. Joe planes based on the 1986 Conquest X-30 mold:

For the more modern Conquests, you may need to remove the landing gear for the mount to engage properly. You can carefully pop the landing gear assembly out with the wheels open. (Not needed for vintage.)

There are two options: a silvery gray that matches most of the Conquest models, and black to better match the Python Patrol version.

A self-drilling drywall anchor and screw are provided. No drilling necessary, unless you are on a stud, then pre-drill with a 3/16" bit. You just screw the anchor into the drywall.

You can see the installation video here:

Tuck in the belly landing gear, and spread the wheels slightly.

The mount has two hooks at one end. Hook them into the gap at the hinge of the belly landing gear and press mount flat against the belly.

Attach the magnetic latch through the hole in the mount. The open face of the latch faces the front of the Conquest.

Attach the acrylic bracket to the wall with the included anchor and screw. Tighten just enough so that the bracket can swivel with some effort.

Line the locking nut of the mount up with the hole in the bracket, and install the screw. Tighten just enough that you can position the plane to your preference, then tighten the screw.

Visit my eBay store for other hard to find vintage Star Wars parts, repair kits, and vehicle wall mounting hangers!