MAVIC 3 Series Triple Mount for Two GoPro style cameras, lights or accessories and a top mount battery and small board mod. These do not block cooling vents. The Mid mounted mount keeps drone in balance. Removes with 4 screws. Turn off Obstacle Avoidance to use or run in sport mode.

Typical install Battery Sequioa Sunlight Sensor UP Facing MultiSpectral under one wing down facing or use your imagination!

There will be several GO Pro style top mount adaptors available starting with the Sequioa Sytems

NOW SNAPs ON if you are in a hurry

we still recomend 1 or 2 screws however works as snap on if needed

DRONE, CAMERA and LIGHT and ADAPTOR NOT INCLUDED

Includes all necessary mounting hardware

Weights:
Triple Mount 90g
Tested Payload Limit 560g (Sequoia Multi Spectral, prop guards, top battery and Sun Light Sensor)

This is for MAVIC 3 Series

1-Includes mounting to accept any 3 GoPro style mounting (see photos)

2- Mount your accessory in almost any position up, down, front or rear facing or at angle

3- Mount your lighting using 1/4 to GoPro swivel adaptors for precise aiming

4- Attaches in a few minutes

5- NEW Version adaptor for Sequoia Available (see ad 7/1/25)

Multiple units are available

MADE IN THE USA

General for All Mounts

We are constantly updating based on field use reports . As a result photos and instructions and components may change

at any time.

Disclaimer

We offer no guarantees that a mount will perform up to your expectations since there are too many variables.

Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.

We assume no responsibility for any damage or injury because of the addition of one of our mounts.

Payload Location and Clearance

When mounting payloads verify against recommended weights and sizes for your drone in manual or

contact manufacturer

If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next:

1-Place your drone with props on and look down from directly above make sure

you have clearance with nothing protruding outside of the drone main body envelope into prop space

2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick

or velcro. Manually move through its full range and make sure there is no interference with the props.

Safeguards

Use a safety lanyard on your mounts. This is one I use : Amazon

MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10