Specifications:

Use water source: tap water

Applicable temperature: 2-70°C.

Filtration process: 304 stainless steel filter

Installation method: Installed on the main water pipe

Material: brass + stainless steel

Filtration accuracy: 5um～110um

Working pressure:1.5～16Kpa

Wastewater flow: 3t/h

Wastewater cycle: 1-2 times / month (approx. 30 seconds each, repeat 3 times)

Installation and usage:

 1. Installation: The pre-filter should be installed perpendicular to the pipeline, with the drain ball valve opening facing down. The direction of the arrow on the valve body indicates the direction of water flow. The drainage ball valve is closed after installation.

 2.1.Drainage: When the lower end of the cup of the former pre-filter accumulates certain dirt, it should be discharged in time. Use a plastic bucket or other utensils placed in the lower end of the drainage ball valve. Or use plastic hose to connect to the ball valve interface to lead the plastic pipe to the drain. Open the drainage ball valve for sewage, sewage time is more than 30 seconds.

 2.2.Cleaning: The filter should be cleaned in time after there are certain adherents on the front-mounted filter.

 2.2.1. Switch off the front-end control valve of the front filter;

 2.2.2. Open the cup clockwise with the special spanner matching tool.

 2.2.3. Remove the cup and O-ring. Strainer device

 2.2.4. Take off the sealing gasket, pull out the strainer, and then clean the filter attached to the screen

 2.2.5. Clean up the filter mesh after the rate of the filter mesh in order. Install the sealing gasket on the filter element and note that the sealing gasket must be fastened into the slot of the filter element.

2.2.6. Put the cartridge into the cup, put on the O-ring, screw the cup into the main body and tighten it counterclockwise with a spanner.

2.2.7. Open the control valve at the front of the device filter and close the drain valve.

Package list:

1 * Filter

2 * Fastening buckle