This listing is for a custom made mounting system for displaying your Star Wars Republic Gunship on your wall. This is for the wall mount only - no ship or figures seen in the pics are provided. This will fit versions from Attack of the Clones, Revenge of the Sith, SAGA, and the Clone Wars Lucky Lekku and Crumb Bumber, from the 3.75" toy line. This will not fit LEGO or other versions. For the Crumb Bomber, the doors will need to be opened. For the rest of the ships, the doors can be open or closed.

I include two easy to use self tapping screw-in drywall anchors and screws with each bracket. You can install this mount with just a screwdriver, but I recommend a drill for installing the drywall anchor.

This mount will allow you to angle your Republic Gunship in different directions out from the wall, but NOT up or down. I do not recommend tilting the bracket as this is a heavy ship.

This product is a hybrid of metal and 3D printed components - so it does have some heft to it, and that is reflected in the shipping price.

To install: 

Attach the heavy duty metal bracket to your wall with the dry-wall anchors and screws. If you are on a stud, a single screw in the top hole may be used. If you are in dry-wall - go with one screw at your own risk, use both to be safe.

Loosen the arm screws slightly and extend them fully as shown in the pics. Retighten.

Remove the screw from the adjustable slot in the rear of the mount. Place the screw through the bracket from the bottom, and back into the nut in the adjustable slot. Move the mount as far forward as possible and tighten enough to hold.

Place your ship as far back to the wall as possible, with the mount arms to either side of the floor. Slide the ship forward and the hooks will engage to the sides of the floor. Push the ship forward until front edge of the support in the middle of the mount is aligned with the rear of the floor opening. The hooks should be fairly tight to the sides of the ship once that alignment is made. If not, you can loosen the arm screws slightly, squeeze them in, and retighten.

This is a big ship. With big wings. And big doors. And you may have other stuff on your walls or just in the way a bit. It may be easier to attach the mount to the ship first, then attach the mount to the metal bracket. Do what's best for your situation.

The arms should hit the sides of the floor just before they get to the doors. This is a very adjustable mount - you can move the ship forward or backwards a little if your setup doesn't align exactly like mine. You can display the ship with the doors open or closed - and again - you can shift things forward or backwards, or angle the mount on the bracket to suit your needs.

Visit my eBay store for other hard to find vintage Star Wars parts, repair kits, and vehicle wall mounting hangers!