RC electric outboard motor. 3d printed casing made with impact and UV resistant PETG filament. Internal parts printed in PLA. The Propeller is printed in gray Resin. Black and White versions available, both with 3v-12v brushed electric motors with 2pin JST female connections soldered (includes JST male connector with 5.9 inches of wire). The propeller is a singular piece made with a resin printer. Tested with 2S Lipo batteries

• Materials: PETG filament, resin, JST male and female connectors included, stainless steel screws, 3v to 12v brushed motor

The motor will connect to any boat with a flat transom that has an transom thickness of under 5mm or about 0.195 inches.

No bearings, so no bearings to clean after use. Shell is not completely water tight so can only submerge in water a little below where JST connection wire comes out of the outboards casing.

🔍 Features:
🔨 Material: High quality PETG,PLA and Resin
🖨️ Process: 3D printing
📏 Dimensions: HEIGHT = 4.37" / 111mm, LENGTH = 2.64" / 67mm, WIDTH = 1.5" / 38mm wide, CONNECTION OPENING = 0.195" / 5mm
🎨 Colors: Black or White

🎁 Perfect for:
🕹️ RC hobbyists
🏠 Desk or shelf decoration


✳️ Photos - Outboard motor only does not include display stand.
✳️ Video - Outboard motor shown in operation on a sample printed boat(not included) powered by a 2S Lipo Battery(not included).