New Wix transmission filter kit.  This is a filter (1), pan gasket (1) and pickup seal (1).  For stock depth transmission pans only.  A factory depth pan for the applications listed below are 2 1/4" deep when measured from inside the pan, 2 3/8" deep when measured on the transmission with the pan installed, you should always check the pan depth to ensure it was not replaced with a different depth pan.  This is a stock replacement kit.  For 4L60E 4-speed automatics (DOES NOT FIT 93 and older 4L60 nor 700R4 models). Fits the following:

94-02 Camaro (all models)
94-02 Firebird/Trans Am (all models)
94-96 Corvette

TECH TIP : Your pan should be flat.  Any imperfections on the pan's sealing surface will cause a leak.  Use a hammer to flatten the bent areas.  Never use a pry bar to remove a transmission pan.  The pickup seal is typically difficult to remove.  We use a pilot bearing puller to remove the seals.  Be very careful not to scratch or damage the pickup inlet area on the transmission or it may leak.  This transmission case is aluminum, and scratches easily.