Focus Scope/Side Wheel for Hawke Vantage Scopes
This JB3D Printed Focus Sidewheels for Hawke Vantage Scopes.
These are a great addition to a great scope!
Rather than using a grub screw the digs into the scope and causes marks, these simply work by pushing the wheel on and tighten up the bolt to clamp the part together and you're all set to go.
The overall diameter of these wheels are roughly 81mm, they do cover part of the IR button but leave enough so it can still be pressed.
These Wheels are offset roughly 6mm to allow the wheel to miss your scope mounts.
These will fit the Hawke Vantage Scopes with a wheel diameter of 33mm please check before ordering.
They are available in black and red.
I can make wheels to fit most scopes providing you can provide accurate measurements, please message me if you need a custom one.
To get the best print quality on these, the front of the wheel is printed upwards meaning that the rear of the ring needs to be supported while printing, this leaves a finish that is slightly rough compared to the front. Although this doesn't effect the functionality of the wheel I like to let people know the reason for this.
Please check out our eBay store for a wide range of related products.