Denon Belt GENUINE from DENON

Denon ADV700

Denon 1000

Denon DVD2200

Denon DVD2800

Denon DVD2900

Denon DVD2910

Denon DVD2930CI

Denon DVD-955

Denon S102

Denon S301

Denon S302

For tracking number of shipment, you MUST chose Priority Mail and pay the higher shipping cost.  Otherwise, it will go US First Class.

WARNING.
1. ALWAYS WORK WITH DISCONNECTED POWER. THERE IS LIVE POWER!!!
 2. NEVER LOOK DIRECTLY AT THE LASER. YOU WILL DAMAGE YOUR EYES.
 3. GROUND YOURSELF TO DISCHARGE ANY STATIC IN YOUR BODY.

The basic procedure to belt replacement is below. See attached picture from the service manual
of DCD-1520 which is very similar to all models listed above.

1. Open the tray and remove disc
2. Turn power off and pull the plug
3. Remove black TOP COVER by remove the four side screws. Some units have one screw in the rear center.
4. Remove galvanized INSIDE BOTTOM COVER
5. Place the cd player vertically on its side. Remove front FRONT PANEL by removing all screws
and then slightly pressing with a small screwdriver on all six hooks. These are plastic locking clicks that
hold the face panel. Do not over press these as you will break them. I have broken a few in the past. Just
 press enough to release pressure. There is a grounding wire connecting front panel to chassis. You can 
pull wire from its connection on the front panel. Set aside front panel
6. Now you can see the top tray belt just below the tray (BELT A). I call this belt long skinny. You can
also see the lower belt B, I call it fat short (BELT B).
7. Remove one belt at a time and clean the grooves of the pulley with cotton swab and some alcohol.
If you have big hands, you may need tweezers or help with a screwdriver.

FOLLOW BELOW STEPS ONLY FOR ENTIRE KIT SYSTEM AND CAN BE SKIPPED.

8. Clean all previous grease under the tray gears with paper towel and alcohol. Then apply this crease 
with a small flat screwdriver. You can apply in other areas of the tray mechanism where plastic to
plastic parts come in contact. See picture with areas boxed in RED.
9. Left side of tray, there is a 5mm metal rod for tray mechanism. Clean and lubricate with Tri-Flow oil.
Do not over lubricate, a thin coat is plenty good
10. Now clean the 2.5mm metal rod that laser moving mechanism slides. Carefully clean and lube.
DO NOT over lubricate.
11. Connect power and turn on. Eject tray and close. If the tray gets stuck or sluggish or not closing
all the way, then, one ore more things can be going on. Belt(s) slipping due to debris or oil. Clean.
Also areas boxed in red and tray gears under tray could overlubed. Wipe away some grease.
12 Test again. If all working assemble back together.

JOE