Class A 430 - 450 MHZ (430/870 MHZ) amateur radio power amplifier TETRA CW SSB FM DATV DVBT DVBS2 - 2 X BLF2045.

This is a very high linearity low power PA, you may use it directly at output of PLUTO SRD or LIME SDR ti build a 70cm transceiver, or a low power high MER DATV DVBT/DVBS transmitter, or a TETRA hotspot.


All the pallet module are modified and each are tested at full  power at 20W CW / SSB / DATV output at 432 Mhz before to shipping.

If you need without mods the original BW is 440/870 MHZ, so i can send also with this range.

The power gain is in the range of 35 dB at 26 Vcc, increasing if you use higher voltage, so you need about + 10 dBm (10 mW)input for a 20 w output.


The module has this caracteristic:

Voltage 24 Vcc, current 3,2 A - PWR +43 dBM 20 W out - 2 tone IMD -22 dBc

Voltage 28 Vcc, current 3,9 A - PWR +43 dBM 20 W out - 2 tone IMD -29 dBc

Voltage 32 Vcc, current 4,1 A - PWR +43 dBM 20 W out - 2 tone IMD -31 dBc



The two LDMOS BLF2045 are rated from datasheet at 30W PEP power output for each one.

The driver is a MRF282Z is rated from datasheet at 10W PEP power output.


This is the perfect drive for the 250 W out PA for a perfect amplifier chain.

https://www.ebay.it/itm/127174050613


You buy one single piece of module for a power output of 20 W CW - PEP, like in the picture.

Of these amplifiers i have sold more units all over the world with complete satisfaction of the buyers.


73 by IK2DED.



I apologize but now i only ship to EU due to the sharp increase in shipping cost to other countries.
For NA - JA - VK it's about 40,00 euro, so, but if you need one unit and if you live outside EU write to me to check shipping rate.

More infos if required at ik2ded@yahoo.it