*Please compare this hanger against your original hanger to be 100% sure it's correct!* :)
*PLEASE TAKE NOTE OF THE MODEL YEARS BELOW BEFORE YOU BUY!*
Fits:
- Corsa, 1, 2 – 2014-2015
- Edge Ti / Team – 2013-2014
- Edge Ti Disc – 2014
- Edge Ti Team - 2014
- Helion Alloy QR (Standard Mount) – 2016
- Helion Comp QR (Standard Mount) – 2015
- Karakoram - 2017
- Pantera (Standard Mount) – 2017
- Ricochet - 2018
- Sensor Alloy QR (Standard Mount) – 2016
- XIZANG 9R frame - 2014
- XIZANG 9R pro - 2014
- XIZANG 9R team - 2014
- XIZANG 2012-2013
- Zaskar 100 - 2011-2013
- Zaskar 100 Elite - 2014
- Zaskar Carbon 9R (Standard Mount) – 2014-2015
- Zaskar LE – 2013
- Zaskar LE (Standard Mount) – 2016
- GT Avalanche Expert 2019
- Avalanche Comp standard mount - 2019
- Avalanche Expert 29 standard mount - 2017-18
* PLEASE BE 100% SURE THIS IS THE CORRECT HANGER YOU NEED BEFORE YOU BUY! *
* Each Hanger will be Fully Inspected prior to despatch! (thread, bolt etc)
* Some May show signs of imperfection in the Aluminium but this doesn't affect the hanger! (Please See Pics)
* It is Always Advisable to have your New Hanger fitted at your Local Bike Shop!
Snapped/ Bent hangers:
Hangers can bend or snap with improper use of the gears (and improper installation), or more commonly, when there is damage to the rear derailleur or hanger due to either a fall or improper storage of the bike. If your hanger and/or rear derailleur are not aligned or damaged, shifting through the gears in this condition can result in the derailleur shifting into the wheel, which can damaged the derailleur beyond repair, snap the hanger, damage the chain and also damage the spokes/ wheel. It is important to check your hanger/ derailleur alignment before each ride.
Gear Hangers should be fitted by a Qualified Cycle Mechanic and only after the original fault that caused the original gear hanger to fail has been rectified! The Gear Hanger is a sacrificial part which is designed to break when the frame and/ or drive train are under excessive stress, reducing/ eliminating any damage that may be caused to the frame and drive train components.
* All hangers are 'straight' when they come from the factory - if the hanger does not appear to be 'straight' after fitting, please be sure to check that your frame drop-out is clean and free from damage (or thick paint)!*