For use only in CR-531 Inside Epoxy 

NOT FOR USE IN EPOXY BOND COAT

Why limit your colors to this planet?

With Liquid Nebula, you can choose from the color palette of the gods…Galactic, Ghost of Jupiter, Super Nova, Helix…20 outrageously beautiful metallic color additives for epoxy.

Made of millions of suspended reflective pigments, Liquid Nebula powder mixes into epoxy to give both residential and commercial spaces the high-end, ultra-modern look so popular today. Use a single color for elegance, or blend colors for a breathtaking effect.

Liquid Nebula offers infinite design possibilities based on color choice and application techniques. The result is a durable, glossy surface with the breathtaking depth of color found only in the cosmos.

Metallic pigment for Epoxy. Add one container of Liquid Nebula metallic pigment to 3 Gallons of Part A Epoxy (or until desired opacity is achieved).

Mixing

• For the base coat, add the appropriate pigment to Part A (resin) and mix thoroughly with a low-speed drill and paint mixer.
• Add the pre-measured Part B (hardener) and mix for 2 minutes.
• Scrape the sides and bottom while mixing and avoid whipping air into the epoxy.
• Accurate proportions and complete mixing are critical; improper mixing can leave the coating soft.
• For Liquid Nebula Metallic, ideally mix the metallic pigment into Part A 24 hours before application. This helps fully wet the pigment and reduces clumps and “comet tail” effects.
• If pre-mixing isn't possible, shake the pigment container and add the entire container to Part A of the 3-gallon CR-531 Inside Epoxy kit, mix completely, then add Part B.
• Multiple metallic colors can be used, but don't overwork them, or the colors will blend together instead of remaining distinct.
• Use only Concrete Resurrection epoxy pigments.

Application

• Base coat: Apply approximately 3–8 mils thick using a roller, squeegee, or trowel. Stay within the specified pot life, temperature, and humidity requirements.
• Metallic coat: Spiked shoes are recommended. Pour the epoxy in a long trail and spread it evenly with a notched/gauge squeegee.
• Allow the material to self-level, then finish by back-rolling with a 3/8" or mohair roller, or use a Magic Trowel, speed squeegee, or loop roller.
• For larger areas, a premium 18" roller with a phenolic core is recommended.