EASYGUARD Plug Play Remote Starter fit for selected Toyota Gas/diesel/Hybrid II Camry Corolla18-21 II Avalon 19-21 II RAV4 19-22.6 II ES300H ES350 18-20 II UX250H 19-21 II RAV4 2.5(Hybrid) European 2021 with push start button Automation LHD Car
EASYGUARD Plug Play Remote Starter fit for selected Toyota Gas/diesel/Hybrid II Camry Corolla18-21 II Avalon 19-21 II RAV4 19-22.6 II ES300H ES350 18-20 II UX250H 19-21 II RAV4 2.5(Hybrid) European 2021 with push start button Automation LHD Car
Compatible vehicle
Don’t work with Key Start Vehicle, fit for push start button car only
Don’t work with manual transmission, fit for automation Transmission Only,
Don’t work with RHD (right hand drive) vehicles, fit for LHD (Left hand drive) vehicles only
Don’t work with Key Start Vehicle, fit for push start button car only
Don’t work with manual transmission, fit for automation Transmission Only,
Don’t work with RHD (right hand drive) vehicles, fit for LHD (Left hand drive) vehicles only
Main function：
3X Lock Remote Start/stop (Note: There is no remote in this kit, use factory original remote/key fobs to remote start/stop. Remote start method: Continue to press original remote lock button 3 times will remote start/stop the car.)
Open Door to Shut down (After remote start the car, when you open the driver door, the car Engine Will Shut Down for Safety consideratio)
No need to change car remote, use factory original remote
Plug and play installation & no damage on car circuit
Wiring method
Programming method
Programming Procedure:
Once the installation is finished, you need to do a new programming.
Before programming, please make sure the engine cover is closed, and ignition is turn OFF.
Step 1: Plug the 4pin & 22pin connector with the Control Module,
Step 2: Don’t step on foot brake pedal. Press the factory push start button twice to turn Ignition to ON Position.
Step 3: The LED will flash red, then flash green color and turn off.
Step 4: Press push start button once to shut down the car
Programming finished.
If the programming procedure is abnormal, please program again or reset it first then program till you program it success.
Programming Procedure:
Once the installation is finished, you need to do a new programming.
Before programming, please make sure the engine cover is closed, and ignition is turn OFF.
Step 1: Plug the 4pin & 22pin connector with the Control Module,
Step 2: Don’t step on foot brake pedal. Press the factory push start button twice to turn Ignition to ON Position.
Step 3: The LED will flash red, then flash green color and turn off.
Step 4: Press push start button once to shut down the car
Programming finished.
If the programming procedure is abnormal, please program again or reset it first then program till you program it success.