Easy to install flag light
The smart brightness detector automatically switches on the light once the sun has set, and turns the light off once it’s bright enough outside. Its thirty-three solar panels recharge the batteries (included) when the sun is up.
We adopt 266 brightest energy-efficient LEDs
Etzeaxus extra-strength LEDs are solar rechargeable and have an extremely long lifespan.
--No need to bring the light to room as it’s waterproof. We adopt a special groove design to insulate the water. Special high grade silicion glue to seal the solar panels.
--Smart small leakout hole design for the case if any water enters, it can leakout success without rust the circuit.
No worry about rainy day anymore.After full charge, it will light 16+ hours.
Of course, the duration depends on the amount of absorbed sunlight. The solar panels collect more power during day, and the light will work more time.
State-of-art design, Self-Charging, Cutting-edge sensor equipped to detect the right time to Auto-Active shinning when it gets dark.
-Lower your pole
-Spin your ball shaft and nut off the pole
-Center the lights' hole over the pole's hole -ENSURE YOU'VE PRESSED THE ON BUTTON so that the light will shine when dark
-Re-insert your ball shaft and nut into both holes -Turn your ball shaft finger tight -Adjust your ball shaft nut as needed -Raise your pole
-Proudly display your patriotism, all day and all night
-Use with most 15 - 25 ft flag poles with a 1/2"-thick rod at top
-Width of hole to fit through ornament shaft or rigged bolt: 0.55 in.