Here's another rarity from my collection. This is my Team Losi XX CR Graphite Buggy. You'll notice I am not calling this a Kinwald Edition, because it's NOT. This was put together from parts, similar to the way I we raced the original Team Losi XX CR Buggy. This is a full Graphite XX CR Buggy with:

  1. STD (Standard Length) Graphite XX Buggy Chassis with all the Graphite Braces
  2. Graphite Front CR Suspension Arms (Yes, they are different than the original XX, because they have the front sway bar mounts)
  3. Graphite Rear CR Suspension Arms
  4. Graphite Rear Shock Tower
  5. Carbon Fiber XX Graphite Front Shock Tower
  6. Carbon Fiber XX Graphite Front Hinge Pin Brace
  7. Team Losi Blue Anodized SPEC Shock Bodies (.6 Front & 1.2 Rear)
  8. Vintage MIP Shiny CVD Dogbones
  9. Team Losi HydraDrive Slipper System
  10. Team Losi Lightweight Aluminum Motor Plate 
  11. Lunsford Titanium Tie Rods/Turnbuckles (With Vintage Team Losi NATURAL Ends)
  12. Team Losi 25° Front Castor Blocks
  13. Team Losi Aluminum 2.19:1 Top Shaft/Gear
  14. Trinity/Kinwald Blue Anodized Aluminum Screw Set
  15. Novak Mercury Shielded 75mhz Receiver
  16. Novak Cyclone Programmable ESC
  17. Futaba S9402 Servo
I really tried to remember as much about this build as I could, but it has been a shelf queen for a very long time. The shocks have never seemed to leak, but I'm sure they could use some oil, after all this time, but the still feel mostly full. I put the last race setup on this buggy, from the way we used to race these. 

EVERYTHING WAS PURCHASED NEW, EXCEPT THE CHASSIS. I had a hard time finding a chassis, even years ago when I was building this, so I ended up with a used chassis that was still in good condition. It does show some wear and scratches from use, but everything else was quite literally purchased new, and specifically for this build. This would be a great shelf queen for someone. Or if you really did want to race this, it has about ever upgrade on it, you would want. You'll notice that the motor plate doesn't even have any marks from having a motor installed. The wires were ready to finish up, and install a motor and maybe a battery, I just never got around to it. 

Please ask any questions, I'll do my best to answer, from what I can remember. Thanks!

NOTE: THERE IS NO MOTOR, GEAR COVER OR BODY, and I will likely lay the antenna down for shipping.