The size of Center Bore is required to be 66.1mm (to hub and to wheel)
The
wheel spacer adapter is attached to the axle contact surface using the
fastening screws supplied. The wheels are attached with the existing
wheel bolts of the standard and special wheels.
Please Make Sure You Take The Proper Measurements Before Purchasing:
Center Bore(CB): 66.1 mm (Car) to 66.1 mm (Wheel)
Thread: M12x1.25
Information on the wheel spacer adapter:
Material: Forged 6061-T6 Aluminium, aircraft grade aluminium, more lighter and strength
Thickness: 35 mm
Widening per axle: 70 mm (35 mm per wheel side)
Bolt circle on hub side: 6x114.3
Bolt circle on rim side: 6x114.3
Wheel Bolts: Grade 12.9 Material bolts, stronger than OEM 8.8 Grade
Warranty: 1 YEAR
Hub Centric Design: with Lip fit tightly to the hub & wheel to reduce any type of vibration or false reading
Machine-Forged precisely from 6061-T6 aircraft-grade aluminium billet, with heat-treated and hardened 12.9 grade bolts pre-installed.
The anodized surface provides additional resistance to corrosion.
Extraordinarily strong and light compared to spacers made of steel.
We recommend customers
start threading the hardware on by hand so as to not cross thread or
strip the threads. Once secured hand tight, use the torque wrench set to
the proper torque. Tighten the wheel bolts/lug nuts one after the other in a criss-cross pattern(as show in the sixth photo). Make Sure You Get 5-7 Turns Before Tightening. Suggested To Be Torqued Down By Hand At 85 FT/LBS.
Under- or
over-tightening wheel-attaching hardware can be damaging and dangerous.
When the lug nuts are over-torqued, this could cause stress fractures
and increasing the risks of the lugs breaking under normal conditions.
If no problems (noise, vibration, anything out of the ordinary), Re-torque all lug nuts after 5-25 miles of driving.
Situation and solution of installation Failed:
If your Center bore height is more than the spacer,
it means you will either have to go with spacer without hub centric lip
OR use thicker spacer. As our hub centric spacer need to have taper to
allow the change of center bore size. if you don't check your Center
bore height. Inner taper will be in the way. On these spacers if your
Center bore height is more than 30mm the installation will fail.
If you are looking to change the PCD of
the car to different PCD you will have to make sure the clearance at
the back of the wheel allows you to commit this changes. Sometimes if
there is a rebate or recess on the back of the wheel, does not mean
there is enough clearance, usually if the stud pattern is changed
dramatically (eg. 5x100 to 5x120) then there might be an issue.
If your car uses lug nuts (stud
extrude from hub to tighten wheel down), you will need to know that if
your studs is protruding out by 28mm and you are buying 15mm spacer, you
will have 13mm extrusion from the surface of the spacer which might
stop the wheels from sitting flat against the spacer. Thus if you get
30mm spacer, you definitely don't have to grind anything for sure.