These PTFE-coated fiberglass sheets help reduce sticking, protect the plate surface from carbon build-up and make clean-down easier during busy service.

Also known as: AU-F7LT4T2AIA

Size check: please match your old sheet or grill plate size before ordering.

10-Pack PTFE Non-Stick Grill Sheets - Compatible with Roband 8-Slice Grills | 495 x 740 mm

Condition: Brand New, Cross-Reference (size only): Roband PGS810 (for identification of dimensions) Dimensions (each): 495 mm x 740 mm (W x L) Material: PTFE-coated fiberglass, food-contact safe, PFOA-free Rated: Heat resistant up to 260 degreesC (500 degreesF) Compatibility: Roband GSA810, GSA815S, GSA810S, GSA815 (8-slice) grill stations; suits RC8 retainer clip (sold separately)

• No returns accepted on fitted or used items.
• All warranty claims must include a qualified technician's report confirming a manufacturing fault.
• Buyer is responsible for equipment compatibility and installation. If unsure, consult a licensed technician.

Sized to match the 8-slice grill station plate, these PTFE non-stick sheets help keep food from adhering to the grill while protecting the plate surface from carbon build-up. They're reusable, easy to clean, and a practical way to reduce downtime between batches. Each sheet can be secured with the RC8 retainer clip (not included) for stable use during service.

• Helps prevent sticking on toasted sandwiches, proteins, and delicate items
• Acts as a barrier to reduce burnt-on residue and simplify end-of-shift clean-down
• Reusable construction-wipe during service, wash in warm soapy water after use

• Exact Size: 495 mm x 740 mm (each sheet)
• Pack Quantity: 10 sheets
• Material: PTFE-coated fiberglass, PFOA-free, food-contact safe
• Temperature: Rated up to 260 degreesC (500 degreesF)
• Compatibility: Size-matched for Roband GSA810, GSA815S, GSA810S, GSA815 (8-slice); suits RC8 retainer clip (sold separately)
• Care: Wipe clean during service; wash with mild detergent; avoid abrasives and sharp tools

Designed to fit grill stations that accept a 495 x 740 mm sheet, including Roband GSA810, GSA815S, GSA810S, and GSA815 (8-slice) models. If your model is not listed, measure your plate or refer to the equipment manual to confirm fit. Retainer clip not included; use RC8 or equivalent as required.

• Allow grill to cool; place sheet flat over the plate
• Secure with RC8 retainer clip where applicable
• Do not exceed 260 degreesC; avoid direct cutting on the sheet
• Clean by wiping during service; wash in warm soapy water, rinse, and air-dry

Is this a genuine Roband part? No. It's an aftermarket, non-OEM sheet made to the same size as the Roband PGS810.

Will it fit my grill? If your grill plate uses a 495 x 740 mm liner (e.g., Roband GSA810, GSA815S, GSA810S, GSA815), it should fit. Please confirm plate dimensions and clip style before ordering.

Are clips included? No. The RC8 retainer clip is sold separately.

How do I clean it? Wipe between batches, then wash in warm soapy water. Avoid abrasive pads and sharp tools that could damage the PTFE surface.

What's the temperature rating? Up to 260 degreesC (500 degreesF). Do not exceed the rated temperature.