Inner Axle Seal Installer Tool for Ford Super Duty Dana 50 60 Axle


  • Fitment: Fits all Ford Super Duty 1978-2016 Dana 50/Dana 60
  • Function: Repair oil leaking from ends of front axle tubes
  • Great Design: Allows installation of expensive oil bath seals without damaging them.

  • Superior Material: Durable Steel Construction, ensuring a long-lasting service time, solid and sturdy.


Fitment:
-- Fits all Ford Super Duty 1978-2016
-- Dana 50 / Dana 60 Applications

Function:
Repair oil leaking from ends of front axle tubes

Great Design:
Allow installation of expensive oil bath seals without damaging them.

Superior Material:
Durable Steel Construction

How to Use:
1. Disassemble the front axle and remove the old inner axle seals using a long screwdriver and hammer to knock them out toward the center from the end of the axle tube.
2. Install a new seal onto the driver as shown above. The seal is designed to snap into place on the adapter.
3. Position the seal driver and seal assembly squarely into the housing as shown.
4. Assemble 1/2 inch extensions as necessary to reach from the seal driver to the outer end of the axle housing.
5.Install the driving adapter onto the last 1/2 inch extension and drive the firmly into place by hammering firmly on the driving adapter.
6. Be sure to seat seal all the way. There will be a significant change in tone when the seal is seated. (the seal driver is designed to set the correct seal depth in the axle and cannot be driven any further when the correct depth is reached.)
7. Remove the seal driver and reassemble the axle.







                    

                     



                             
                             
                             
                             


Fitment:
-- Fits all Ford Super Duty 1978-2016
-- Dana 50 / Dana 60 Applications

Function:
Repair oil leaking from ends of front axle tubes

Great Design:
Allow installation of expensive oil bath seals without damaging them.

Superior Material:
Durable Steel Construction

How to Use:
1. Disassemble the front axle and remove the old inner axle seals using a long screwdriver and hammer to knock them out toward the center from the end of the axle tube.
2. Install a new seal onto the driver as shown above. The seal is designed to snap into place on the adapter.
3. Position the seal driver and seal assembly squarely into the housing as shown.
4. Assemble 1/2 inch extensions as necessary to reach from the seal driver to the outer end of the axle housing.
5.Install the driving adapter onto the last 1/2 inch extension and drive the firmly into place by hammering firmly on the driving adapter.
6. Be sure to seat seal all the way. There will be a significant change in tone when the seal is seated. (the seal driver is designed to set the correct seal depth in the axle and cannot be driven any further when the correct depth is reached.)
7. Remove the seal driver and reassemble the axle.