IMPORTANT - CHECK YOUR OLD RELAY BEFORE ORDERING
Miele dishwashers can use two different heater relay types depending on age and production version.
This listing is for the older style heater relay, part number 6002930.
Please do not order by dishwasher model number only. Before buying, compare your old relay with the photos and check:
* Part number on the relay
* Relay shape and mounting
* Terminal layout
* Connector position
If your old relay does not match this part, this relay will not fit or repair the fault, even if your dishwasher shows F24 or a heater relay fault.
F24 can be caused by the heater relay, but it can also be caused by other heating circuit faults. Match the relay first before ordering.
Genuine Miele Dishwasher Heater Relay OEM | Part #6002930
Condition: Brand New, Genuine OEM
Part Number: 6002930
Rated: 220240V AC, 16A, 50/60Hz
Manufacturer: Schrack (Tyco Electronics, Austria)
Return Policy
- No returns accepted on fitted or used items.
- All warranty claims must include a qualified technicians report confirming the part is faulty.
- Buyer is responsible for compatibility and installation. Consult a licensed technician if unsure.
Product Overview
This is a genuine Schrack (Tyco Electronics) heater relay used in the power control module of many Miele dishwashers. Common symptoms of failure include:
- Error code F24
- No heat / cold wash cycles
- Clicking or buzzing noises from relay
- Burnt PCB near relay contacts
Rated for 16A @ 250V AC with bifurcated contacts and >3mm contact gap. OEM design is optimized for 230V Australian mains.
Important Disclaimer
The F24 error can have multiple causes, not just the heater relay. If replacing this relay doesnt fix the issue, it may not be the source of the problem. A licensed technician should perform a full diagnosis. Refunds or warranty claims require a written technicians report confirming the relay is faulty.
Key Features
- OEM Quality: Manufactured by Schrack Tyco Electronics (original Miele supplier)
- Relay Type: RAST 5 double-pole, normally open (2NO)
- Terminals: 6.3mm quick-connect push terminals
- Mounting: Snap or screw-fit to control board
- Safety: 4kV coil-to-contact insulation, >3mm contact gap
- Optimized for AU: Designed for 230V Australian mains vs older 200V variants
Model Compatibility
Compatible Brand: Miele
Compatible Models:
DIY Installation Notes
- Always disconnect power before service
- Remove panel and locate control board (front/top access)
- Unplug existing relay, match terminal layout
- Snap/screw into place and reassemble
- No reprogramming required
Suitable for experienced DIYers or licensed technicians. Approx. installation time: 1530 minutes.
Frequently Asked Questions (FAQ)
Is this a genuine Miele part?
This is an OEM part made by Schrack (Tyco Electronics) the same supplier used by Miele.
Is this version better for Australia?
Yes. It is optimized for 230V, the standard in Australian homes, offering improved reliability and lower heat output.
What does the relay control?
It controls the heating circuit on/off via the control board. A faulty relay often causes water not to heat and triggers error F24.
Can I install this myself?
Yes, if you have electrical experience. Otherwise, hire a technician. It is plug-compatible and needs no software reset. Note: warranty support is void if not installed by a licensed technician.
Whats your return policy?
No returns accepted if the part is installed or packaging is opened. Faulty claims require a technicians report.