This listing is for a pressed panel to repair the nearside outer sill on RHD T4's. If you're reading this, you probably know that you can only buy the outer sill for LHDs which means a bit of messing about making the panel fit.

This panel is a home made replica of the end closest to the rear wheel arch, 3D scanned, 3D printed, aluminium casted then pressed to form the panel. It is not a perfect replica, edges need trimming and hammering to fit, but it massively reduces the time it would take to alter the LHD panel.

It is pressed out of 1mm mild steel.

On the end of the sill cloest to the passenger door, you just cut the end off as pictured and while not the same as OEM, it is usable without altering.

The main sill panel is not included, this is only for the right hand corner that I have made.