Please note Nissan Data Scan II software is not supplied. It must be purchased from the app store

The Nissan DataScan II is intended for newer Nissan cars equipped with gray 16 pin OBDII connecter and use the Consult II protocol over K line (DDL2). The connector is usually located near the fuse box.

A list of cars that the software has been tested on is located on the website. The list is by no means comprehensive and is constantly being updated as new vehicles are tested.

NOTE: NOT COMPATIBLE with 2008+ cars that use the CAN BUS protocol. Some vehicles up to year 2004 use OBDII (K-Line) for communicating with the ECU, BUT still use the Consult I (14pin) port for diagnostics.

Functions: 

• ECU Part Number
• Data Display ECM
• Data Display Settings
• Data Logging
• Self Diagnostics
• Idle Adjustment
• Timing Adjustment
• Active Test ECM
• Program Immobilizer Key
• Cylinder Power Test
• Log Analyzer
• Speed Test
• Data Replay
• Address Watch
• Wideband O2 sensor
• BCM Functions
• TCM Functions
• ABS Functions
• SRS Functions

 For the full list of functions, please see the Nissan DataScan II product page

Specifications

• Compatible OS: Windows XP 7 8 10 (32/64 bit)
• Chip: FTDI FT232RL
• Diagnostic Interface: 16 pin OBDII J1962
  
• USB Interface: 2.0
• Voltage: 12V (no external power supply required)
• Length: 1.8m

Connected Pins:

• PIN 4: Chassis Ground
• PIN 7: K-LINE ISO9141
• PIN 15: L-LINE (KWP2000)
• PIN 16: +12V Power