Overview:
- DIY alarm system with the capability to add up to 40 sensors, 10 remotes, and 10 doorbell buttons.
- Programmed and ready to use right out of the box.
- Inexpensive and simple intruder alarm system
- Can be easily transported and set up in different locations
- No network, GSM, or Wi-Fi capabilities required
- Press the "S" button on the remote to trigger the panic alarm

Suitable Applications:
- Sheds, garages, barns, shops, single-story homes, cabins, RVs, and other small spaces that need protection

Technical Specifications:
- Dimensions: 12mm x 10.2mm x 11mm
- Power: AC 110V to 220V, 92cm/3ft power cable (can be extended)
- Wireless frequency: 433MHz
- Operating environment: -15°C to 55°C, 40% to 70% relative humidity
- Typical wireless range: 328ft (100m) in open areas, reduced by obstacles 

Siren
- Can pair with up to 40 wireless sensors and 10 remote controls
- Alarm volume up to 115dB
- Wireless range of approximately 100m, reduced by obstacles

Remote Control:
- Arm: Activates the alarm, triggering siren if sensors are tripped
- Disarm: Deactivates the alarm and stops the siren
- SOS: Triggers the siren alarm for emergency assistance
- Test: Sounds a "Didi-Didi" test beep from the siren

Setup and Usage:

1. Connect the siren unit to a power outlet.
2. Remove the insulation strip from the alarm sensors to activate them.
   - Door/window sensor will flash once when turned on.
   - Open the motion detector, check battery polarity, then turn it on.
3. Mount the sensors in the desired locations, drilling may be required for the motion detector.  

Pairing Process:  
1. Connect the siren to power, wait 6 seconds.
2. Disconnect and reconnect the siren's power 3 times.
   - The siren will beep each time.
3. After the 3rd beep, the siren will enter pairing mode.
4. Pair the sensors:
   - Motion detector: Turn it on to pair.
   - Door/window sensor: Separate it from the magnet.
   - Remote: Press any button to pair.
5. Once all devices are paired, disconnect the siren's power to exit pairing mode.
6. Reconnect the siren to complete the setup.  

Sensor Specifications:
- PIR Sensor:
  - 110° horizontal, 60° vertical detection angle
  - Detect distance: 0-8m  

Key Features:
- Weatherproof design
- No GSM card, WiFi, or app required
- No ongoing subscription fees  

 

 

 

  

Q&A:

Q: Do I need to order an alarm panel (control center) for this siren?

A: No, this siren work as an alarm system, it can work with wireless sensors to protect your house.

A: Yes! This siren alarm system can work with 6 remote controllers and 30 wireless sensors like wireless gas detectors, smoke detectors, co carbon detectors, door/window sensors, pir motion detectors, water leakage sensors, vibration sensors and glass break detectors and so on.

A: Yes! User can use 1 remote controller to control 2 or more siren systems, or 1 sensors work with 2 or more siren.