3 PackTRV/Thermostatic Radiator Valve ADAPTORS FOR Danfoss Models ONLY.

ALL 3 SIZES.

Fits 99% of all known Danfoss Models !

Suitable for older, pre 1999 radiator Valves with the now Obsolete Pushfit fixing, and this then Converts it to the Modern 2025 Standard 30mm/M30 Ring-Screw fitting.

Very Easy to fit, it just screws on by hand.(Full Easy Setup instructions are included.)

NO TOOLS.

NO Plumbers required ! ( Save £50-£150 per Radiator. )

NO EXPENSIVE IMPERIAL TO METRIC CONVERTERS, NOR ADAPTORS NEEDED.

(These normally would cost you an extra £15 to £25 per Radiator, depending on the Manufacturer, Age, and Brand Model of the original Valve.

This is a tough Fibre-Composite Shatter proof Adaptor, not cheap brittle plastic like others.

Fitting time, 2 Minutes !

To Check your TRV size, simply remove the Head, and measure the width of the metal radiator valve where the head clamps onto, the bit with 4 notches, it should be around either 22, 25, or 34mm Approx.

Still not sure?

Just ask us !

Click on CONTACT SELLER, at the top of this page, by our Feedback score.