Specifications:

100% Brand New
Size: 16 * 12 * 7.0MM
Plug type: ZH1.5
Working voltage: 3.7-8.4V
Working temperature: -10°C~50°C
Dual sensitivity mode: Master sensitivity mode/Stable anti shake mode

Setting and usage instructions
Gyroscope steering stroke (EPA) setting:
    Press and hold the SET button, turn on the power until the indicator light changes from red and blue flashing to constant light, and then release it. At this point, the gyroscope enters the EPA travel setting function. Rotate the remote control handwheel to the left to make the vehicle turn left to the desired angle, keep the handwheel still, and after 3 seconds, the direction will automatically return to the center. At this point, the left steering EPA stroke setting is successful; Rotate the remote control handwheel to the right again to make the vehicle turn right to the desired angle, keep the handwheel still, and after 3 seconds, the direction will automatically return to the center. At this point, the EPA travel setting for the right turn is successful. Turn off the power and restart to end the setup.
Sensitivity direction setting:
    The sensitivity direction has been synchronized with the EPA travel setting, and following the left to right setting sequence is the correct direction
Gyroscope sensitivity adjustment and dual-mode selection:
    The sensitivity of the gyroscope can be adjusted through the remote control knob channel. The range of travel from 0 to -100 is the high sensitivity mode (red light mode), and from 0 to+100 is the stable anti shake mode (blue light mode). Alternatively, you can adjust it through the potentiometer on the gyroscope module (where the horizontal sensitivity is 0, and the sensitivity increases as you go up or down). Note that after connecting the gyroscope sensitivity adjustment channel to the receiver, the potentiometer on the module cannot adjust the gyroscope sensitivity