Details:
1.
The AT35 series scanning galvanometer system consists of a scanning
drive part and a scanning click part. It has fast speed, high precision,
high durability, and high stability.
2.
The system circuit is simple, efficient, stable, with clear device
layout structure and reasonable and rigorous wiring. Add power
protection circuits to ensure the long-term safe operation of the
vibrating mirror.
Parameters:
Power supply voltage: ± 15V/1A
Analog signal input impedance: 200K ± 1% Ω (differential input)
Analog position input range: ± 5V, ± 10V (you need which type you can inform)
Working temperature: 0-50 ℃
Scanning angle: ± 30 ° Optical angle (factory setting ± 20 °)
Lens reflectivity: 99% @ 45 ° incidence (covering wavelengths: 400nm-680nm)
Driver board size: 80x64.5x31.6mm
Scanning speed: 30K
Note：
1.Before
starting work, the drive board and motor base must be fixed on a large
metal plate, and attention should be paid to maintaining good air
convection for heat dissipation.
2.
When leaving the factory, the scanning system is equipped with various
connecting wires. If users use other wires to connect them themselves,
please refer to the wiring diagram of the driver board; The motor serial
number and scanning serial number must be consistent, with X and Y
drive boards and motors corresponding to each other, otherwise it will
result in asymmetric patterns, such as circles turning into ellipses.
3.
The scanning board has been calibrated before leaving the factory.
Except for the IS potentiometer, users are not allowed to calibrate
other potentiometers, otherwise it may damage the galvanometer.
According to the usage requirements, the pattern size can be adjusted
using potentiometer IS. Reverse rotation will increase the pattern, but
it cannot be infinitely increased, otherwise it may damage the
galvanometer. And both drive boards need to be adjusted symmetrically at
the same time, otherwise the pattern printed will deform, such as a
circle turning into an ellipse.
4. Do not plug or unplug various connecting wires with power on, otherwise the vibrating mirror will be damaged.
5.
When there is abnormal noise or other abnormal phenomena during
startup, please shut down immediately, troubleshoot and restart to avoid
damaging the vibrating mirror.