A brand new replacement bezel manufactured in 316L stainless steel and PVD coated semi gloss black. The macro photos make the finish of the bezel appear to have a slight orange peel effect, but in hand they look very smooth and almost indistinguishable from their resin counterpart.
A set of 4 brand new replacement (non genuine) bezel screws.
Made in a limited batch using highly corrosion resistant 316L stainless steel. An accurate reproduction that has been machined to match the original screw to within +/- 0.05mm.
As per the original, the head of the screw has been polished to a mirror finish.
Note: the original bezel screws have been fitted with a thread locking compound. Slow and careful removal by hand is essential to prevent the screws from breaking within the case.
You will need a flat screwdriver that's between 2mm to 2.5mm wide and up to 0.4mm thick. The perfect fitting screw driver for these screws is the VESSEL 2.3 x 0.35 ⊖ Purple, code 251354. Also available in a set as VESSEL TD-55 or TD-56. With care you may also use the larger WERA 2035 Kraftform Micro Slotted Screwdriver, 2.5 x 0.35 x 40 mm.
1. To remove the old bezel screws, carefully and slowly turn the screw head anti-clockwise 1/4 a turn and re-tighten a 1/8 of a turn. This will help break the factory thread locking compound. Repeat this procedure until the screw is full removed or until very little resistance to unscrewing is felt. Clean out any thread locking compound from the screw holes to ensure the new screws fits and seats fully.
2. Once all four screws have been removed, remove the bezel and clean the bezel mating surfaces with isopropyl alcohol.
3. Fit the new bezel and replace with a new set of screws. You may wish to add a hairline amount of low strength thread locker (such as Loctite 222) using the tip of a needle or pin to part of the thread. Alternatively a hairline amount of superglue can be used, once again applied with the tip of a pin or needle. Ensure no thread locker makes contact between the underside of the screw head and the watch case.
If you have any other questions, please do get in touch.
Please note, the watch is not included and for illustration purposes only.