5/10Pcs SOIC8 SOP8 Flash Chip IC Test Clips Socket Adpter BIOS/24/25/93 Programmer
Instructions:
The total length of the clip is approximately 42CM
The total length of the clip is approximately 42CM
Pinch the chip as far as possible to open the clamp head. The red edge corresponds to the first pin of the chip clamp, and the blue board indicates the first pin of the plug-in programmer. These two points are correct
Wide and Narrow 8-Foot Universal Clip.
Specification:
Test clip: SOIC 8/ SOP8
Connector type: Test Clip
Pin format: SOIC / SOP
Qty:5/10Pcs
Test clip: SOIC 8/ SOP8
Connector type: Test Clip
Pin format: SOIC / SOP
Qty:5/10Pcs
Package included:
5/10Pcs SOIC8 SOP8 Flash Chip IC Test Clip
Before purchasing, please note:
Some boards can directly clamp the chip, but some boards cannot be operated in this way because the chip on the board will be affected by the peripheral circuit. Please be aware of this before placing an order, so as not to buy it back and make it unusable.
Some boards can directly clamp the chip, but some boards cannot be operated in this way because the chip on the board will be affected by the peripheral circuit. Please be aware of this before placing an order, so as not to buy it back and make it unusable.
Chip soldering is like a universal mount that can be used directly, and both wide and narrow bodies are compatible
Many high-power programmers can basically be used normally (such as programmers with external power sources such as Shenglong, Zhou Ligong, Sylt, etc.)
When encountering a programmer with a protected function, the clamp cannot read at normal voltage, and a voltage of 3.3V needs to be applied.
The method is to clamp the chip with a clip, and apply a voltage of 3.3V to the pin corresponding to pin 8 of the chip.
Generally, a 3.3V power supply has two wires, so VCC should be connected to the clamp, and the other wire should be directly grounded.
On Mar 15, 2025 at 00:21:24 PDT, seller added the following information: