Prepare: Clean the headlight lens with water. Mask off the surrounding perimeter of the lens to avoid scratching the paint of the vehicle.

Step1. Sand

Wet the sanding disc and attach it to the backer pad. Sand with three different grits to completely remove the heavy yellowing, fading, and corrosion.

Note: Use the sanding discs from coarse to fine: P800--> P1200--P2000. Not doing so will result in restoration failure

Step2. Polish

Attach. the orange sponge disc to the backer pad and apply the polish paste. Polish the lens until the shine is restored to its condition.

Note: For best results, use an electric buffer or polisher. If polishing by hand, polish with no less than 200 strokes in a circular, clockwise motion.

Step3.UV Protection Liquid (Important)

Clean the headlight lens and make sure the lens is dry before the protection step. Use the white sponge disc provided in the kit. Evenly apply the protect liquid on the surface of the lens. After apply it, stay for 10-15mins to let the liquid flow evenly itself. Then dry it direct sunlight immediately (1 to 2 hours is suggested). if not, dust and other dirt will adhere to protect liquid due to its viscosity, which will affect the brightness of the headlight.                                 

Note: Please must avoid any sunlight when apply the protect liquid on headlight (very important). After step 3, keep the lens dry. Do not wash the car for 24 hours

Step4. About removing the Masking Tape

After finishing all the steps, please remove the mask tape, otherwise the longer the time, the harder it is to remove and may leave traces