WE ARE AN AUTHORIZED AUDIO-TECHNICA DEALER!

OPEN-BOX

The AT-OC9XML Dual Moving Coil cartridge with Microlinear stylus is designed to provide outstanding channel separation. The Pure Copper by Ohno Continuous Casting (PCOCC) coils ensure pure audio transmission and are aligned in a reverse V-shaped formation to exert less pressure on the stylus, thereby minimizing distortion. Audio quality is further enhanced by a rigid aluminum body that reduces resonance, a neodymium magnet and premium permendur yoke that increase the magnetic energy, and the nude Microlinear stylus on a boron cantilever that tracks the record groove with incredible accuracy, low distortion and high-transient response. The cartridge body has been pre-threaded, enabling it to be mounted to a headshell or integral tonearm with just two screws – no nuts required.

• Dual Moving Coil design, featuring independent coils for both left and right channels, provides outstanding channel separation

• The coils are aligned in a reverse V-shaped formation, which exerts less pressure on the stylus, thereby minimizing distortion

• The cartridge body is pre-threaded, enabling it to be mounted onto the headshell or integral tonearm with just two screws – no nuts required

• Nude Microlinear stylus and boron cantilever provide lower distortion and high transient response

• A neodymium magnet and a premium permendur yoke with high saturation flux density and outstanding magnetic properties further enhance the concentrated magnetic field of the coil gap

• Aluminum body minimizes unwanted vibration for reduced resonance and superior audio reproduction

• Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve pure signal transfer

Type	Dual Moving Coil
Body Material	Aluminum
Frequency Response	20-47,000 Hz
Channel Separation	27 dB (1 kHz)
Vertical Tracking Angle	20°
Vertical Tracking Force	1.8-2.2 g (2.0 g standard)
Recommended Load Impedance	Min. 100 ohms (when head amplifier is connected)
Coil Impedance	12 ohms (1 kHz)
DC Resistance	12 ohms
Coil Inductance	25 mH (1 kHz)
Output	0.4 mV (at 1 kHz, 5 cm/sec)
Channel Balance	1.0 dB (1 kHz)
Stylus Shape	Microlinear
Stylus Type	Nude square shank
Stylus Curvature Radius	2.2 x 0.12 mil
Cantilever	0.28 mm diameter nude boron
Static Compliance	20 x 10-6 cm/dyne
Dynamic Compliance	16 x 10-6 cm/dyne (100 Hz)
Wire Used for Coil	PCOCC
Terminal Pins	Brass
Mount	Half-inch
Weight	7.6 g (0.3 oz)
Dimensions	17.3 mm (0.68") H × 16.8 mm (0.66") W × 25.7 mm (1.01") D
Accessories Included	Non-magnetic screwdriver; 2 washers; cartridge installation screws (5 mm × 2, 8 mm × 2, 10 mm x 2, 12 mm x 2); plastic protector; brush

Mounting Feature: Threaded body

Note: moving coil cartridges require receivers or preamps with compatible inputs; their stylus assemblies are not field-replaceable.