Set of four (4) high performance BOSCH EV14 - 1000cc/min fuel injectors. These are HIGH IMPEDANCE so NO resistor boxes are necessary! If you have a resistor box from factory, you must bypass it. Also included are the proper USCAR to OBD0/OBD1 electrical adapters for a direct fit, NO SPLICING REQUIRED!

We use specialized ASNU testing equipment to ensure the injectors are precisely matched to achieve equal cylinder to cylinder fuelling. You will receive a flow matched set under +/- 1.5% at multiple flow data points, accompanied by a unique flow sheet for your set. We also supply the necessary calibration data (dead time/offset/latency/lag time) to input into your tuning software.

This set is custom milled from NEW Bosch cores. Fuel discharge is through a single hole with a medium cone spray pattern for superior fuel atomization. This set can support up to 550bhp @ 90% duty(3bar FP), and over 630bhp at 4bar.

This set is covered by our best 2yr unlimited mile warranty.

Applications:
Honda fitment guide:
- 1988-1991 Civic/Crx - Remove/bypass resistor box
- 1992-1995 Civic/Del Sol  
- Will Also fit all OBD0 & OBD1  Euro & JDM D-series engines.

FLOW RATES & Specs:
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: medium cone, (single orifice)
Electrical Connector: USCAR
Fitted with Viton upper and lower o-rings.
Static Flow Rate (gasoline) @ 43.5PSI (300kPa): 95 lb/hr = 6.52g/s = 1000cc/min (900cc/min with n-Heptane)
Overall Length: 65.5mm
Dimensions: 48.5mm o-ring seat to seat, 53.5mm o-ring centerline to centerline