NEW NO RETAIL BOX NEVER BEEN USED: You will get it as shown
in the photos
Blackmagic Design ATEM 1 M/E Production Studio Switcher 4K IS NOT INCLUDED
This listing is only for 1 Internal Power Supply, it does not included any other things which are mentioned here
- OEM Replacement Updated Internal power supply for ATEM 1 M/E
Production Studio Switcher 4K, ATEM 1 M/E Production Studio 4K, ATEM Talkback Converter 4K, ATEM Studio Converter
- A must have backup power supply for BMD SWATEMPSW1ME4K
- A perfect replacement for originally BMD Clicking power supply
- It does not click like the one it came originally with ATEM
1 M/E Production Studio Switcher 4K
- If you do not know what click we talking about see the blog
link at the bottom
- Task difficulty: Simple to Mild, takes approximately 5 minutes
- We recommend you take to a professional technician to
replace it for you, If you do it Please note you doing this at your Owen risk.
- You need remove 16 screws total to replace this power supply
- Task difficulty: Simple to Mild depending on your knowledge
of electronics
- We recommend you take to a professional technician to
replace it for you, If you do it Please note you doing this at your Owen risk.
- To replace the power supply follow these simple instructions
and see the photos and illustrations provided on this listing.
- What is included: Internal Power Supply only
- Compatible Blackmagic Design Units
ATEM 1 M/E Production Studio 4K, ATEM Production Studio 4K, ATEM Talkback Converter 4K, ATEM Studio Converter
How to replace
Warring High voltage! Please note you do this at your Owen risk. Disconnect
form AC power. Locate and Remove all the
12 screws from the top cover (please see photos) and take picture of the power
supply and Pay attention to polarity before removal of power supply. Disconnect
the 3 Molex connectors for the power supply and circuit board. Remove the 6-Pin to Molex 4-Pin Power Adapter
Cable and re- terminate/ reconnect the Molex Power Cable according to the polarity
(please see photos) . Replace the new
power supply and put back the 4 hexagon screws.
Then Put the cover back using the 12 screws which you removed from the top
cover. You are done. Please see the
provided illustration and photos to help you. If you are unfamiliar with what
is communicated above we recommend you take to a professional technician to
replace it for you. Please note you doing
this at your Owen risk.
Blackmagic Design ATEM 1 M/E Production Studio Switcher 4K IS NOT INCLUDED