SUMMARY:
This LCD battery monitor is a battery specific residual battery monitor. With low power
consumption, can be a long time to show the battery power; It can be used in all kinds of light
conditions with LCD screen. Suitable for lithium batteries, lead-acid batteries and other applications; simple wiring, using standard connector, convenient maintenance and disassembly.
 
 
IMPORT FEATURES:
  • Liquid crystal material,display clear
  • The percentage of the remaining power,voltage,clear and directly
  • Customize the type of battery,suitable for plumbous acid,3.7V lithium battery multi section series
  • The 8~65V wide input voltage,reverse protection
  • The custom 10S later sleep,0.3V fluctuation can automatic wake-up sleep in 0.5S
  • Low power consumption,5mA with the backlight on,20uA when sleep
  • Reservation function expansion
 
INSTRUCTIONS:
1. PH2.0 terminal products supporting the use of wire,connected to corresponding plug on the back of circuit board.
2. Two wires,red is positive and black is negative,received battery ends.
3. The electric quantity display has been used to work normally,and the backlight is shown to be bright,the metal part of the device can not be touched.
4. LCD screen surface has a layer of protective film, the installation of a fixed ,should be torn off,so as not to affect the LCD contrast and beautiful appearance.
5. This device of the default is the percentage for display.Press the switch, switch to the voltage interface, press the switch again, the device will be closed.
6. The left area of the display has a battery indicator, if we have full of power it will display 7 bars. And the right area is for percentage display.
7. When the power is lower than the lowest value, the percentage is 0%, while the backlight is off, and the power consumption is low.
8. The remaining capacity of the battery, the no-load state of the battery is measured, that is, non charging and discharging state.
9. When the voltage is greater than 50V, such as the long time of the electric charge, it will produce a certain amount of heat on the back.which is normal condition.
 
 
FUNCTION SETTING:
1. Hold down the product switch, connecting the power supply, will enter the selection
interface.
2. Select the appropriate type of battery,cut the power, then connecte the power supply, the
part of choosing is down.
3. If the device is only used to display the voltage, there is no need to set the battery type, and
the voltage range is 8~65V.

Special Function Setting: (Need electric iron)
A Point Connect: The custom 10S later sleep,0.3V fluctuation can automatic wake-up sleep in 0.5S
B Point Connect: Lithium 3~4.1V curve (the function for custom models, the actual shipment may vary)
C Point Connect: Display the LOGO of manufacturer
D Point Connect: Reservation function expansion
 
 
ATTENTION:
1. LCD screen for glass material, for fragile items,it can not withstand strong stresses.
2. LCD screen is sensitive to UV,so can not be long-term in a large number of ultraviolet ray radiation environment or will shorten the life of the LCD screen.
3. LCD screen is more obvious than the use of environmental temperature,in the low temperature (5 °C ) the
following use, contrast may be reduced, but the temperature returned to normal, contrast will recover.
4. Products are parts of the module,the negative elements exposed, please pay attention to the dust and water,insulation.
 
Package include:
  • 1 x Battery Tester