Welcome to our page!

For sale we have our custom made 5 x 112 GOLF MK5

  Wheel Spacers sold in pairs with 10 x 37mm thread M14 x 1.5 HT wheel bolts

OUR 10MM SPACERS ARE NOT SUITABLE FOR THE R32 MODEL OF THE GOLF 5 RANGE AS THE HUB SPIGOTS ARE TOO LONG
THESE SPACERS WILL NOT FIT ANY AUDI OR VW WHERE THE HUB SPIGOT LENGTH IS LONGER THAN 9.9MM (WHICH IS 99.9% OF THEM)


Please note these will only fit the front hubs on the GOLF 5 
THE SPACERS WILL SNAP IF YOUR HUB SPIGOTS ARE TOO LONG
IT IS BUYERS RESPONSIBILTY TO MEASURE THE FRONT HUB SPIGOTS BEFORE PURCHASING
(YOU MAY NEED TO REMOVE BOTH DUSTCAPS IF PRESENT ON THE FRONT HUBS)


Radius bolts are sent out with this listing
for original/oem wheels

****THESE SPACERS WILL NOT FIT THE REAR HUBS****
Spacers are 10mm wide giving 20mm overall increase across the axle.

All of our custom made spacers and adapters are manufactured from 6082 billet Aluminium in our Barnsley HQ



One of the most cost-effective mods on the market and easy to fit in 7 steps

  • Simply unbolt your wheel and remove.
  • Wire brush and wipe the bore and wheel hub clean, (must be dirt/rust free)
  • Apply a little copper grease or similar to stop the faces sticking together.
  • Slide the spacer on to your existing hub.
  • Check the spacer is sitting flush against the original hub with no visible gap
  • Gently position the wheel on to the spacer spigot taking care not to damage the machined surfaces.
  • Secure the wheel with the extended bolts and torque them to the required spec.

Watfields Precision Engineering also manufacture custom parts as well as wheel spacers and adapters.

All our wheel spacers are manufactured from material sourced in the UK and are produced by Watfields Precision Engineering UK LTD. 

Please contact us to discuss any enquiries you may have