Welcome to our page!

For sale we have 2 of our custom made 5 x 112 GOLF MK5 SPACERS

PERFECT FOR INSTALLING A STUD AND NUT KIT ON YOUR GOLF 5

THESE SPACERS WILL NOT FIT ANY AUDI OR VW WHERE THE HUB SPIGOT LENGTH IS LONGER THAN 9.9MM (WHICH IS 99.9% OF THEM)
Please note these will only fit the front axle if the hub SPIGOT/LIP is less than 10mm long
IT IS BUYERS RESPONSIBILITY TO MEASURE THE FRONT HUB SPIGOT/LIP LENGTH BEFORE PURCHASING

IF YOU ARE WANTING 10MM 5X112 57.1 SPACERS AND DON'T OWN A MK5 GOLF PLEASE REMOVE THE FRONT WHEEL AND MEASURE THE HUB LIP FROM THE HUB SURFACE TO THE END OF THE LIP 
UNDER 10MM IN LENGTH?? THEN THESE WILL FIT.

Spacers are 10mm wide giving 20mm overall increase across the axle.


All of our custom made spacers and adapters are manufactured from 6082 billet Aluminium in our Barnsley HQ




One of the most cost-effective mods on the market and easy to fit in 7 steps

  • Simply unbolt your wheel and remove.
  • Wire brush and wipe the bore and wheel hub clean, (must be dirt/rust free)
  • Apply a little copper grease or similar to stop the faces sticking together.
  • Slide the spacer on to your existing hub.
  • Check the spacer is sitting flush against the original hub with no visible gap
  • Gently position the wheel on to the spacer spigot taking care not to damage the machined surfaces.
  • Secure the wheel with the extended bolts and torque them to the required spec.

Watfields Precision Engineering also manufacture custom parts as well as wheel spacers and adapters.

All our wheel spacers are manufactured from material sourced in the UK and are produced by Watfields Precision Engineering UK LTD.

Please contact us to discuss any enquiries you may have