Stand By Time
- Time knob is used for setting working time from 1-10 minutes when it detects motion.
- Time setting only works in Auto Mode.
|
Sensor Sensitivity
- For setting ambient brightness value to differ from daytime tonight. If the ambient brightness value exceeds the setting Lux, it is defined as "daytime"; otherwise it's known as "nighttime".
- Position 0 equals 3 Lux, Position ∞ equals max Lux and it's always regarded as night no matter how bright around the sensor.
- Lux setting only works in Auto Mode and D2D Mode.
|
Detecting Range
- Rotate the knob to adjust the sensing range to max ca. 50ft motion coverage.
- When you mount the light over 7.8ft, please adjust the sensor upwards and set the max range to increase the coverage area. Time setting only works in Auto Mode.
- Range setting only works in Test Mode and Auto Mode.
|
Attention
- Make sure that there are no infrared or ambient lights pointing towards the motion sensor.
- Make sure that there are no other influence factors that affect the performance of light.
- Be sure to disconnect the power before you install the light.
- Be sure to mount it in a dry location, humid environment is not good for light's lifespan.
|