Ultra Thickness
Garage wall protector strips are 1.18" thickness, twice the thickness than other brands. Better to provide full protection for your car door and garage wall, preventing damage from any potential impacts when parking in the garage.

Easy Install and Removal
This car door & bumper protector use fiberglass mesh adhesive. You just need to peel off the backing paper and stick it on the wall. The interlaced fiberglass allows the wall protectors to be removed without tearing the soft protector or leaving marks on the wall.

Suitable for Many Surfaces
The car door edge guards pads are water resistance and anti-scratch. Made of high-quality Eco-friendly EVA Foam. Easy to clean. Fit for almost all smooth surfaces like concrete, plaster, wood, metal, etc.

Widely Use
This garage wall anti-scratch protector is perfectly used in parking spaces, warehouse, mechanical insulation, pipe insulation, vehicle collision avoidance. ensures both sides of car doors and garage walls will be protected.

How to Install
1.Please clean your garage wall surface firstly and ensure it is smooth, non-dust, dry, remove any particles on it.
2.Measure the size and mark the places you want to put it on.
3.Peel off the backing paper and apply the protector on the wall, make sure it is straight and no space between it.
4.Repeat the same steps above for the other side of your garage wall.
5.Be careful, the garage wall protector could not adjust after start to adhere to the wall.

Note
1.Please do not put under extremely high temperature or exposure to the sun for long;
2.Protectors can be removed without leaving marks on the most of the surfaces (e.g. brick, tile, glass, or marble walls). But the removal on a brittle or lime wall pavement may need to do it with care because the adhesive is very strong.

Package Included
2x / 4 x Garage Wall Protector Pads(1.18x3.9x11.8 inch)(as you choose)