Welcome to our page!

For sale we have our custom made 4 x 100 NON HUBCENTRIC Wheel Spacers/shims sold in pairs

Spacers are 3mm wide giving 6mm overall increase across the axle.

PLEASE NOTE THESE SPACERS MAY HAVE SURFACE MARKS ON THE DUE TO THE LASER CUTTING PROCESS

These spacers are designed to fit a 57.1mm HUB and wheel bore. VW fitment.

One of the most cost effective mods on the market and easy to fit. 

• Simply unbolt your wheel 

• Give the bore of the wheel and the face of the hub a good scrub with a wire brush to clean off any dirt, rust or debris, 

• Apply a little copper grease or similar to stop the faces sticking together 

• Slide the spacer on to your existing hub. 

• Check the spacer is sitting flush against the original hub with no visible gap, 

• Gently position the wheel on to the spacer spigot taking care not to damage the machined surfaces, 

• Secure the wheel with extended bolts and torque them to the required manufacturers spec.

Watfields Precision Engineering also manufacture custom parts as well as wheel spacers and adapters. Please contact us to discuss any enquiries you may have.