The LRM 140 motor control is designed to provide start/stop and E-stop functions for any machine
with an existing magnetic contactor installed. If a Magnetic contactor is not installed on the machine you will need to purchase the Lovegreen LRM MAG. Electrical wiring by a qualified technician is required.
Motor Control
- Push-button set for machine's magnetic motor starter
- Designed for control voltage only - 120 VAC or less
- Not designed for control voltages above 120 VAC
- Start / Stop / E-Stop
- Plastic box
- OSHA and NFPA 79 compliant
- UL and C-UL listed
- NO power outage protection
Control motor motors with Start / Stop and latching emergency stop switch set. This device controls your machine's magnetic motor starter. (Control voltage only - not line voltage) If your machine does not have magnetics, you will need to contact an electrical contractor to install motor magnetics.
A qualified electrician required for hard wired installation. Mount the controller on your machine within operator's reach. Wire into the machine's control circuit and remove existing control if necessary.