Heavy-duty machined pivot or linkage pin with a flanged shoulder, cross-drilled retaining hole, and tapered/chamfered installation end. The shaft measures approximately 79.91 mm (3.146 in), corresponding closely to a nominal 80 mm pin.
No manufacturer name, part number, or confirmed equipment application was found. This pin is therefore being offered by its measured dimensions. Please compare every critical measurement with the pin being replaced.
Measured Dimensions
- Overall length: approximately 428.6 mm (16-7/8 in)
- Main shaft diameter: approximately 79.91 mm (3.146 in)
- Flanged shoulder diameter: approximately 84.38 mm (3.322 in)
- Shoulder thickness: approximately 6.35 mm (1/4 in)
- Cross-hole diameter: approximately 21.72 mm (0.855 in)
- Cross-hole center to tapered end: approximately 20.64 mm (13/16 in)
Features
- Nominal 80 mm shaft diameter
- Integral flanged shoulder
- Transverse retaining-pin hole
- Tapered or chamfered installation end
- Machined heavy-equipment replacement-pin configuration
- No manufacturer or part number identified
Condition
Unused surplus pin with cosmetic scratches, handling marks, and minor surface discoloration from storage. No original packaging, retaining hardware, bushings, or additional components are included.
Equipment fitment has not been identified or verified. An 80 mm diameter alone does not establish compatibility. The buyer is responsible for comparing the overall length, usable shaft length, shoulder dimensions, cross-hole diameter, and cross-hole placement with the original pin. Please do not purchase solely by equipment make or general appearance.
Returns must be received in the same condition in which the item was shipped. Please verify all measurements before installation. Pins showing installation, hammering, grinding, welding, machining, or other alteration cannot be returned as being in their original condition.
Included: One flanged pivot pin only, exactly as pictured.