Please specify if you need a collimating lens installed. The PL530EC model includes a pre-installed collimating lens.
1. Complete PL530 laser source with close loop controlled laser current, heater current and TEC temperature integrated in one heat-sink box.
2. Over5 0 mW laser output power.
3. Narrow spectral line width, perfect for Holography and Interferometry.
- Operating Temperature:
10C to 40C
- Storage
Temperature: -40C to 85C
-Wavelength:
530nm to 534nm
-Wavelength
Stability:+/-0.1nm
- Spectral Line Width:< 0.1nm
- Output
Power: > 50mW
- Residue
Infrared Laser Output: < 2mW
- Beam Quality: M2 <1.3,TEM00
-
Polarization Extinction Ratio: 100:1 (typical)
- Beam Divergence Angle: < 8mrad without collimating
lens
- Beam Divergence Angle: < 2mrad with collimating lens
- Power
Supply: 5 VDC
- Power consumption:< 7.5 W
- Dimension: 75x55x25 mm
Operation Notes for PL530 Laser Module PL530E
(Rev. 11-14-23)
1.
Refer
to the included Panel Layout drawing for the operation functions of the module.
2.
Connect
+5VDC (2 Amp) power supply to the power jack.
3.
Slide
the ON/OFF switch to ON position to turn on the power. The “Temp Good” LED will
flash between RED and GREEN colors, wait a few seconds for the LED color
turning to GREEN completely.
4.
Once
the “Temp Good” LED is stabilized on Green, press the “Laser Enable” pushbutton
switch to enable the laser power and the “Laser Enable” LED will change the
color from RED to GREEN
5.
The
green light beam will output from the small window. Please be aware of that
don’t look the window directly when the power is on.
6.
The
laser power can reach to over 50 mW when shipped, but it may change or reduce
the power at the later time.
7.
To
get the desired laser power output rather than the default settings, users can
adjust the laser and heater potentiometers to change it. The heater current has
a significate effect to the power output.
8.
The
default settings are: the laser current preset to 450 mA (limited to 480 mA),
the heater current to 66 mA (limited 100 mA) approximately.