A simple and economic solution to combat unwanted vibrational noise! - throw away your plastic feet and apply a set of four self-adhesive soft silicone case feet! A great deal of PC case feet are solid plastic, or (at best) very hard rubber and therefore do a good job of transmitting unwanted vibrations from inside a PC via the chassis/case into the desk, floor or shelf on which the system sits. In this situation, where the case is in direct contact with the substrate, the PC can generate annoying noise elsewhere (secondary noise).

Acousti Products have designed a unique pack of four self-adhesive silicone feet available in different softnesses (to support different weights). These feet are designed to decouple a PC case from the floor or other hard resting surface by absorbing vibrational energy, and therefore helping to minimise noise generation caused by vibrations.

A little extreme? Well, yes, perhaps: but even with very quiet PCs it is vibration that becomes the most significant culprit/contributor to noise generation. So these case feet have been developed to try and minimise vibrations in the pursuit of ‘ultimate noise reduction’. We hope you enjoy the difference!

Multiple Applications

Anti-vibration case feet are not just limited to combating PC noise and for vibration control in their application - they may be useful for Inkjet and Laser Printers, HiFi Separates, TVs, Small Form Factor PCs, Home Theatre PCs, and any number of appliances and enclosures that would benefit from vibration adsorption and reduction. Speaker cabinets may also be a useful application for these feet - helping to isolate the speaker cabinet from the surface on which it sits. These feet are low-profile (7mm high), so they won’t necessarily be seen, and they are non-marking. The rounded edge is designed specifically to dampen vibration transmission in multiple planes.