Dreamcast Full Screw Set (Lid Mechanism/Springs/Light Shade)

this is an ideal replacement set for your Dreamcast 

Included in the official Kit as follows 

1 x Lid Latch for the eject Button (Spring Included)

1 x Lid Gear (Black) (With Spring)

1 x Lid Hinge 

1 x Lid Light Shade

2 x Latch eject Screws (These have the gold washers on them)

7 x Small round screws (5 are used to secure the lid Hinge/Light shade/Lid Gear (Black) (2 x used for the fan) (1 Extra Screw)

2 X Long Black screws (Used on the modem)

11 x Black Screws (7 Used around to secure motherboard and the other four are for the Dreamcast housing when opening up the console 1 extra screw included in case buyer loses any

9 x Gold screws (2 used for the power switch/3 x for the GD-Rom/ 2 x screw into the left hand side of the motherboard (1 x extra screws included in case buyer loses any

4 x Long gold screws for the controller port PCB

(Please read this) i have worked with Dreamcast consoles for many years and the amount of people that forget that the four long gold screws must be used for the controller port PCB (Using these screws To Secure the GD-Rom Drive will damage the motherboard as they are a lot longer than the ones that should be used and destroy the very fine traces to the motherboard,

If you have any questions regarding this listing, please ask and i will get back to you as soon as i can

Check out my other listings for various console parts 

Thanks for looking and good luck