Product Description

Chassis In One Rust Stabilising Primer (Single pack, Fast drying, CIO) Description. CIO is a fast drying, single pack true corrosion inhibitor. Contains rust stabilising pigment, and reinforced with self-leafing glass flake. Features 1. Glass flake improves longevity through a reduction in porosity, and an increase in abrasion resistance. 2. Direct to Rust. Chemically modifies corrosion over time to a more stable state 3. Damp Substrate tolerant, and excellent wetting out properties. 4. Fast Cure. Touch dry in as little as 3 minutes. Technical 8M2/1000ML theoretical. 7m2/1000ML typical* (coverage will vary depending on application method, porosity, temperature and profile of the substrate). DFT WET 122 microns DFT DRY 50 microns 41% Solids Application Brush, Roller, Buzzweld Underbody gun (neat, may require warming), thinned >5% normal fixed underbody gun, >15% conventional finishing gun (also available in aerosol), airless spray (3000 psi). 2c>35c application temperature. Always Two coats. Finish(s) Satin (textured finsh avaiable when rolled using a wool roller) Colour(s) Black Storage Protect from frost, in cool conmditions and keep dry. Surface Preparation Best practive is to remove existing coating(s), degrease using a water solubale degreaser, and panel wipe. Loose / friable corrosion must be removed. Wash down with clean fresh water and allow to dry. For aluminium the surface must be keyed otherwise the product will not have a sifficient key for adhesion. Where a key cannot be presented an etch primer should be used. Use of abrasive meda at low rpm low grit is typically sufficient. Prepare to ST2 standard of EN ISO 8501-1:2007 or equivalent. Ensure all scale and contamination is removed, wash down with clean water prior to application, and allow to dry. When blasting blast clean to sa1 standard of EN ISO 8501-1:2007 or equivalent with a surface profile of 50 to 75 microns (steel). All surfaces should be free from oil, grease, contamination, powdery flash rust, heavy rust and be firm and clean. Flash Point 21ºC - 32ºC. Health And safety at all times observe precautionary notices on containers. Refer to Material Safety Data Sheets available on request.