EMAS MK1KIM1 Microswitch Short Hinge Lever (1 C.O. Contact)

Metal Short Lever 1CO MK1 Series Micro Switch The MK1KIM1 pairs a compact metal short-lever actuator with a changeover contact, so you can wire it as normally open or normally closed depending on what your circuit needs — no separate N.O./N.C. variants to stock. Its short lever suits tight-clearance detection points where a longer roller lever wouldn't fit. See also EMAS's MK1KIM2 (medium lever), MK1KIM3 (long lever), MK1MIM1 (roller lever), and MK1PUP1 (plunger) for other actuator styles. 10A rated for resistive loads or 6A for inductive. By choosing EMAS you can be assured of safety and quality, microswitches are UKCA and CE marked. Changeover contact allows for normally closed or normally open wiring. Fast on crimps or soldered connection. Technical Details Product Micro Switch Contact 1CO Actuator Short Lever Current (Ie) 6 A (250V AC) Usage Category AC15 Mechanical Life (Min Qty) 10000000 Electrical Life (Min Qty) 100000 Operating Frequency (On-Off/Hour) Mech. 3000 Elec. 1200 Insulation Voltage (Ui) 660V Impulse Withstand Voltage (Uimp) 2.5 kV Dielectric Strength (Body-Contact) 1,890V AC Dielectric Strength (Contact-Contact) 1,890V AC Isolation Resistance 10 MΩ min. (500V DC) Operating Temperature -25 / +80 °C Pollution Degree 3 Protection Degree IP20 Contact Material AgNi Cable Section Terminal 6,3*0,8 mm Short Circuit Breaking Capacity (Ics) 1 kA Serial MK1 Series Actuator Material Metal Frequently Asked Questions Why is it rated both 6A and 10A? 6A is the standard AC15 inductive load rating; 10A applies to purely resistive loads. Check which load type your circuit switches — inductive loads (motors, solenoids) need the lower 6A figure. Can I wire this as normally open or normally closed? Yes — the changeover (C.O.) contact supports either wiring configuration from the same part, so you don't need to stock separate N.O. and N.C. variants. What's the difference between the short, middle, and long lever versions? The lever length changes how far the actuator needs to travel before switching and how much clearance it needs — shorter levers suit tighter installations. See MK1KIM2 (medium) and MK1KIM3 (long) for more reach and mechanical advantage. Is this suitable for washdown areas? It's IP20 rated, suited to standard indoor equipment rather than washdown or outdoor environments. Industry Applications Machine guarding & position sensing — compact detection in tight-clearance mounting points Panel builders & OEMs — general-purpose end-of-travel and interlock switching Appliance & equipment repair — replacement microswitch for a wide range of applications