HOW TO APPLY
1- Wash hair with step 1 max acted, massaging the hair until abundant foam.
2- Repeat until the hair is completely clean. Note the areas behind the ear and neck.
3- Thoroughly dry the hair with the help of only a hairdryer. Is not Necessary brush process.
4- Divide hair in 4 equal parts. Place the step 2  in a non-metallic container and use . With a brush apply the step 2 in each section of hair starting at the nape and following to the top of the head. Apply the product in small quantity, spreading all the wires enough to let them moist. Keep about 1cm away from the hair root.
5- After the application of the product, wait 15 to 20 minutes for better absorption of the product by wires. Comb the hair back, keeping them straight.
6- Divide the hair into 4 parts and start the brush process, piece by piece. Brush wires with the help of a hot dryer until the hair becomes loose. Then apply the ceramic board part by 10 to 20 times on each side. Wait 10 minutes for the hair gets cold.
7- Rinse thoroughly with water at normal room temperature.
8- Apply the balsam finish step 3 throughout the hair massaging for about 3 minutes.
9- Rinse the hair again.
10- End drying the hair, without using the brush procedure to visualize the result.