12 Volt 3amp ON-OFF Toyota & Suzuki Push Switch
TWIN L.E.D LIGHTS
This Switch Suits the following models ONLY:
86 (Subaru BRZ / Scion FR-S)
2012 - 2020
FJ Cruiser (roof console only)
2011 - 2016
Hilux GUN Series
09/2015 - 11/2025
Landcruiser 200 Series
2008 - Current
Landcruiser 79 Series (Plastic Dash)
Right side of steering wheel
2021 - Current
Prado 150 Series
2010 - Current
Suzuki Jimny JB64W JB74W
2018 - Current
Please check the hole size before purchase
This 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 32.5 mm x 22 mm and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
- Single Pole Single Throw ON - OFF PUSH switch
- Black hard surface
- Laser etched Legend
- Single upper L.E.D light in GREEN
- Single lower L.E.D light in RED
- Upper light is ON when the switch is pressed IN
- Lower light can be wired to separate dash light circuit
- Rated at 3Amp 12V
- Wire Plug and wiring diagram supplied with switch
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
Dash Panel with AOBSW900 series Push Switches
Panel shown from 2013 LandCruiser 200 series. This Panel is mounted on the right side of the steering wheel.
AOBSW900 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSW900 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR logo)