This listing is for one (1) clamp and insert.

Fiber optic ADSS Cable Clamp
Suspension & Support ~  cable diameter .576-.625 in

New old stock ~ never field installed on utility poles or structures 

The Fiber Optic Support Clamp system is designed to gently but firmly support ADSS cable. It is intended for tangent support installations on lines that feature relatively low voltages, short spans, and modest mechanical loads.

  • Mounts to a pole with a 5/8" through bolt or with a 1-1/4" wide x 0.040" thick (32 mm x 1 mm) steel band

  • Supports span lengths up to 600 ft (183 m) NESC Heavy for cables with diameters less than 1.0" and 300 ft (91 m) NESC Heavy for cables with diameters greater than 1.0"

  • Supports line angles up to 20 degrees • Base and keeper are made from aluminum alloy

  • Inserts are made from a soft, pliable dielectric material that gently grips and cushions the cable within the housing

  • Hinged keeper is secured to the base with a captured galvanized steel bolt, lock washer, and washer

  • Multiple assemblies can be stacked together for multi-cable installations

  • Cable cavity is contoured and smooth to allow it to be used as a stringing traveler at the structure

 

Note: purchaser to confirm inserts are for ADSS fiber optic cable diameter of cable supplied by others; see above for cable diameter 
Note: some o-rings temporarily holding clamp bolts in place may require replacement by buyer, if applicable (apply cable tie temporarily to bolt or apply tape, or replace o-ring) depending on your method of use during cable install; one time open and close to place cable, or removing insert to use as traveler and then reinstall insert.