12 Volt 3amp Horizontal ON-OFF TOYOTA PUSH Switch
NEW LIGHT GREEN COLOUR
WARNING
This switch is to control the aftermarket towing mirrors that come with the mirror fold function.
You must purchase a reversing relay to use this switch which will control the in and out function of the mirrors.
This switch will not work without the reversing relay and CAN NOT be plugged directly into the wiring supplied with the mirrors or with the OE wiring of the vehicle.
This Switch Suits the following models ONLY:
Hilux KUN26R, GGN15R, GGN25R
2005 - Early 2015
Landcruiser 76 / 78 / 79 Series
Plastic Dash
Landcruiser 100 Series
1998 - 2007
Prado 120 Series
2003 - 2009
Tundra (Centre console if exists)
2005 - 2006
This Switch will not fit the new Hilux GUN series
Please check the hole size before purchase
This 12 volt push switch from AOB is a single pole single throw ON-OFF switch designed to operate your 12 volt accessories. It has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
- Single Pole Single Throw ON-OFF PUSH switch
- Black hard surface
- Laser etched Legend
- Single left L.E.D light in LIGHT GREEN
- Single right L.E.D light in LIGHT GREEN
- Left light is ON when the switch is pressed IN
- Right light can be wired to separate dash light circuit
- Rated at 3Amp 12V
- Wire Plug and wiring diagram supplied with switch
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's.Therefore in ALL cases the accessory MUST be wired through a fused relay.
Example of Dash Panel with AOBSW800 series Push Switches
Panel shown from 2010 Hilux SR5. This Panel is mounted on the right side of the steering wheel.
AOBSW800 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSW800 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the AIR COMP logo)